First, paint wall decoration materials The commonly used coatings for home decoration are latex paint, water-soluble paint, and colorful paint. The composition and appearance of these three types of paint are not the same. In the end, what is the difference between the paints that can be used in interior wall decoration in the market? 1, latex paint Latex interior wall coatings are medium-to-high grade coatings, although they are more expensive. However, due to its excellent performance and decorative effects, the market share occupied by it is increasing. A good latex paint layer has good water, alkali, and wash resistant coatings that will not peel off after exposure to moisture. In general (under the same conditions of pigment, volume, and concentration), styrene-acrylic emulsion paint is better than EPR paint in water resistance, alkali resistance, scrub resistance, and ethylene-propylene emulsion paint than polyvinyl acetate latex paint (known as latex paint). it is good. 2, water-soluble paint This type of paint is a low-grade product. It is made by dissolving polyvinyl alcohol in water and adding other additives such as pigments. There are many defects in this type of paint, such as not water, not alkali, the coating easily peel off after moisture, it is a low-grade interior wall decorative paint products, mainly for interior wall decoration. Water-soluble paint is cheap, non-toxic, odorless, and easy to construct, accounting for about 50% of the market. It is mostly used for interior and interior decoration of middle and low-end homes or temporary residences. 3, colorful paint Colorful paint is a popular coating material in the market. The film-forming material of the paint is nitrocellulose. The oil-in-water form is dispersed in the water phase. A single spray can form a variety of color patterns. Second, veneer wall materials There are two main types of veneer wall materials: facing tiles or panels and wallpaper wall coverings. 1. Wall facing brick or board material Decorative panels such as marble slabs, granite slabs, etc., but the higher purchase price, generally used for exterior finishes, interior finishes, especially in home decoration rarely used. Common decorative tiles include porcelain tiles, ceramic mosaic tiles (mosaic), glass mosaic tiles (glass mosaic). Has a unique hygiene and easy to clean and fresh and beautiful decorative effect, commonly used in home decoration kitchen, bathroom and other face. 2, wall wallpaper wall covering material Wall decoration fabric is currently the most widely used wall decoration material in China. The wall decoration is deeply loved by the users for its flexible patterns, rich color, appearance of the imitation of traditional materials, and special effects produced by the unique soft texture to soften the space beautification environment. The base materials of these wallpapers and wall coverings are all plastic, cloth based, etc. Their functions are sound absorption, heat insulation, antibacterial, arson, mildew proof, and good water resistance. In the hotel, residential, office buildings, dance halls, theaters and other decorative interior wall and ceiling applications are more common. Third, plaster type wall decoration materials Plastering wall materials are divided into general plastering and plastering. 1, decorative plaster materials Decorative Plastering Finishing Decoration Plastering There are water brush stone, dry sticky stone, false stone, cement brushing and other types. Decorative plastering generally refers to the use of cement, lime mortar, plaster and other basic materials, in addition to the general plastering of the wall, the use of different construction methods directly to the wall surface finishes. It is more decorative than ordinary plastering, and the grade and cost are higher. In addition to having the same function as general plastering, it also has its own special decorative process, so its finishes often have distinctive artistic features and strong decorative effects. 2, general plaster material General plastering construction The general plastering materials include lime mortar, mixed mortar, and cement mortar. In order to ensure that the plaster is smooth and solid, and to avoid cracking and shedding, it must be stratified in construction and construction, and each layer should not be too thick. The thickness of various plastering layers depends on the nature of the base material, the type of mortar selected, and the requirements for the quality of the plaster. Plastering finishes are generally divided into bottom, middle, and top layers. The role and requirements of each layer are different. Tap a wall with several layers of paper with a special steel needle hammer (10g) to check the hollowness of the wall. Check if there is empty drum on the wall, hit a wall with a wooden hammer or something, and the sound produced when you knock on the empty drum is not true and it is easy to hear it. Make a mark and fill it with putty during the renovation. To check if the wall is leaking, it is best to observe it on the second day after the rain falls before the house is turned over. Specially check the wall for water stains, especially for some gables, kitchen bathroom tops, exterior walls and other places. If there are water stains, there is leakage. In addition to the seepage of water in the walls, there is a problem that the wall is cracked. General wall cracks are better checked When the ambient light is dark, use a high-power light bulb (200 watts) to illuminate. When the light is on, the wall ceiling is flat and it will be immediately seen through the shadow of light. If it is not flat, it must be replenished with putty paint; if it is partially painted (patched Over) will make a difference with the color of the wall. Use a long ruler, etc., near the floor of the wall to check if the wall is flat. Check the wall putty, whether it is waterproof putty, you can bring a bottle of mineral water, splash water on the wall, hand touch to see if there is mud on the hand, if not to prove that the wall of waterproof putty qualified. The national standard requirements for wall flatness and verticality are measured using a 2 meter ruler with errors within plus or minus 3 mm. The error in the verticality or flatness of the wall surface is large, and it has a great influence on the appearance of the later decoration. The error in the flatness and verticality of the wall surface will greatly affect the placement of the kicking feet, doors, and wardrobes in the later period. Pulling hair is poorly cured and can be wiped off by hand. Some kitchens and kitchens have poor quality of the wall coverings, and the sand content of the napped layer is too large. The collection layer can be used to wipe off the napped layer directly. This type of shorn handling can easily cause ceramic tile falling off in the later tiling process. The best method of acceptance criteria for home-installed walls is to turn on the lights in the house at night to perform actual visual inspections. Because the walls are actually constructed, due to the technical or carelessness of construction workers, uneven or partial scars occur in some places. Difficult to see, it can only be discovered by turning on the lights at night, which is very important, otherwise, after careless acceptance, the problem found after the check-in is very troublesome. The above is what Xiaobian shared for 2015. What materials should be used to decorate the walls should be determined according to different spaces so that the wall decoration can be more reasonable and beautiful. For more exciting information, please continue to pay attention to this site. Wall color wall paint wall paint
Drag bits Include PDC Drag Bit and step drag bit .
They are usually designed for use in soft formations such as sand, clay, or some soft rock. Their uses include drilling water wells, mining, geothermal, environmental and exploration drilling.
Whenever possible, they should be used to drill pilot holes, for they produce cuttings are easiest to log.
Normally drag bits are 3 wings, but we can make 4 or 5 wings following your drawings or samples.
Many special designs are available upon your request.
Drag Bit Drag Bit , Drag Drill Bits , Step-Type Drag Bit , Drilling Drag Bit China Drag Bit , China Drag Drill Bits , China Step-Type Drag Bit CANGZHOU GREAT DRILL BITS CO., LTD , https://www.triconerockbits.com
2016 What kind of material is good for house decoration ? For wall decoration, there have always been a variety of different voices. Some families think that coatings are more affordable, others think wallpapers are better, and some people prefer ceramic tiles for convenience and convenience. In fact, a variety of decorative materials have their own advantages, home decoration can also choose different decorative materials in accordance with the functional needs of different rooms. Let's take a look at what material is good for the 2016 house decoration wall and the knowledge of acceptance of new house walls.