Polycrystalline Silicon Solar Panel 6x10 Polycrystalline Silicon Solar Panel 6X10,Polycrystalline Solar Panel,Panel Solar System,Silicon Solar Panel ZHONGWEI CITY YINYANG NEW ENERGY , https://www.yinyangnewenergy.com
Analysis: Whether the door lock is equipped with battery; bad connection or wrong connection of the connection cable; bad treatment measures of the sensor panel: install a new battery, check the connection line, replace the sensor panel , and the guest card has a green light, no fault codes, and no motor. sound
Analysis: Low battery power; bad sensor panel; bad core motor; bad connection or wrong connection of the cable; incorrect software operation during card processing Action: Replace new battery, check cable, replace sensor panel or cylinder (motor) , The correct operation of the business card 3, guest card induction green light, there is a motor sound but can not open the door
Analysis: iron bar between the front panel and the lock cylinder is not a good butt; red and beep sounding <br> <br> analysis induction bad cylinder 4, the guest card, the card manager, cleaning cards and other cards: When the door lock time out or overtime processing measures: re-time card refresh the door lock time 5, guest card, manager card, clean card, etc. when the card is activated red light and ring twice
Analysis: Door lock termination service processing measures: In the computer software recovery card in the door lock induction, resume normal operation 6, guest card, manager card, clean card, etc. The card sensor is a red light and ring six sound
Analysis: Guest card and door lock address do not match. Measures: Check whether the room number of the guest card matches the door lock address. Check if the floor area of ​​the management card matches the door lock address. 7. The buzzer keeps ringing
Analysis: The door is not closed; the battery is not enough; the cylinder core is damaged. Measures: Check whether the door is closed, replace the new battery, replace the lock cylinder 8, set the time card, address card, turn red, or have no sound
Analysis: The card is not set up correctly; the door lock circuit board is not initialized Action: Reset the correct card, initialize the circuit board (in the back of the circuit board has a four-foot button)
1. The guest card is silent, no light, no motor action when sensing