After the silicon ingot is cut into silicon blocks, due to the cutting of the silicon block, the size of the cut silicon blocks may be different, and there are some small blocks, but this is not in line with the recycling standards, if recycling will cause great costs. waste. However, in the cutting process, the low rate of qualified cutting will have a great impact on production. So here are some ideas for small block cutting. Previously, the method of processing small pieces was to measure the size of the small pieces first, then measure the small pieces to a good size, and then stick them together with a stick glue, bond them into a stick, and then glue them to the glass, at least Using four small pieces or more, but the operation is more troublesome, because each two small pieces can be cured after curing, so it usually takes 8 hours to bond a saw piece (4 crystal bars) (normal crystal rod, 8 hours can be bonded 10 saw), in addition, in the cutting process will appear neat film, or due to plastic soft glue, resulting in thick slices and even cut oblique, so the cut pass rate is greatly reduced. Now consider no longer use stick glue, but directly to the small pieces stuck to the glass, but in the small pieces to maintain a suitable gap, about 10-15mm, pay attention to be sure to stick flat to avoid affecting the cutting effect. Led Holiday Light,Outdoor Christmas Lights,Christmas Tree Lights,Led Christmas Lights Yuyao Flylit Appliance Co.,Ltd , https://www.yyflylit.com