Many people are accustomed to using squatting pans, but squatting pans are not safe for elderly elders. In some homes, elders’ owners will change squatting pans to toilets so that the elderly can use them more easily. How to change the squatting pan to the toilet ? Here's to give you a brief introduction to the way to change the squatting toilet and precautions, a friend in need can look! How to change toilet seats 1. First, close the water valve that was originally connected to the squatting pan, and then prepare the toilet and related operating tools to be installed. Note that the squatting pan must be changed with a professional master to carry out the construction. 2. After removing the squatting pan, check whether the drain function of the sewer pipe is smooth. A simple test can be used to quickly pour a full bucket of water into the sewers to see if the flow is smooth. If there is a blockage, it must be cleared first. After confirming the patency of the sewer, the length of the sewer pipe is lengthened so that the floor is sufficient to install the toilet bowl. 3. Then use the cement slurry for waterproofing. The waterproof performance of the toilet is extremely important because the previous waterproof layer may be destroyed when the squatting pan is removed. Therefore, the waterproofing process must be performed again. 4. Determine the specific location of the installation toilet, you can install and fix. It is important to note that the position of the selected toilet seat must be precise. Once installed, it cannot be changed. This step is very important. 5. After the toilet is installed, tile it again and use it after the floor is dry. During the process of changing the toilet from the squatting pan, we must pay attention to avoid damaging the sewer pipe of the toilet. The waterproofing project can not be ignored. Once these tasks are not done properly, they will directly affect the use of the results in the later period. If they are repaired again, they will consume more human and material resources. Squat toilet to change the toilet precautions 1, the length of the water pipe The squat toilet is installed below the bathroom floor because it is in the pit and the water pipe is relatively short. After changing to the toilet, the height of the toilet is much higher than the ground, and the length of the sewer's sewer is not enough. In the construction of toilet seats, it is necessary to measure the length of the sewers, increase them, and pay attention to whether the lengthened parts are tight and tight, or they will suffer endlessly after using them. Hole spacing is one of the biggest problems when you change your seat. The hole pitch of the squatting pan is not the same as the hole pitch of the toilet bowl. Before the squatting pan is removed, it is difficult to estimate the actual hole pitch. Many people found that there was no way to install the toilet after they bought it. Before you change your stool, you must ask a professional to help estimate the measurement, and then buy the toilet, so the error will be relatively small. Xiaobian Summary: The above is method Notes toilet squatting pan change Xiaobian to introduce change and squatting pan toilet, Squat toilet is quite troublesome to change things, so be sure to pay special attention to the mounting hope The above can help you, if you need more information, please continue to pay attention to this site. Squat toilet to change the toilet Shenzhen Sunson Tech Co., Ltd , https://www.sunsonkiosk.com
2, hole distance 