In general, in order to achieve the desired laying effect, the quality of ceramic tile accounts for 70%, ceramic laying techniques occupy 30%. Without a good tile, it is difficult to obtain good results even if it is laid; but even if there is a high-quality tile, tiles are wasted if it is not laid.

Paving tiles should be carried out according to the following work:

First, according to the design requirements, according to the tile color, pattern, etc. try spelling number; remove the cracks, drop angle, warping and surface defects of the tiles. Then wet the tiles with water and dry the surface to be paved. When cement mortar is used as the binding layer, the volume ratio of the cement sand should be 1:4-1:6, and should be mixed with water and the thickness of the bonding layer should be 20-35mm. The bonding layer and the ceramic tile should be paved at the same time. Slurry or dry mud sprinkler for bonding. The paved tiles should be smooth, straight and inlaid correctly. After each tile is inlaid, use a small round wooden stick to gently tap on the four corners and center of the tile to ensure that the brick body is in complete contact with the cement mortar and the tiles are Flat ground. The surface of the tile surface shall be clean, smooth, and solid; the width of the joint between porcelain plates shall meet the design requirements; when the design is not specified, the width of the joint shall not be greater than 1 mm. In practice, in order to reduce the seam width, strict engineering requires the application of glass glue on the four corners of the tile for two purposes. First, the glass glue can prevent penetration, and the color of the glass glue is Transparent, therefore, the seam between tiles and tiles can be covered in the most effective way; Second, to prevent the thermal expansion and contraction of tiles. After the tile surface is laid, its surface should be protected. After the strength of the cement mortar of the bonding layer meets the requirements, the first cleaning can be carried out and the wax can be smooth and bright.

Tile Laying Villa Design Cement Glass Glass Tile Tile

Composite Mdf Door

Mdf Door,Composite Mdf Door,Entry Mdf Door

Zhentong Door Industry Co., Ltd. , http://www.china-steelsecuritydoor.com